|
|
I used Tinkercad to create this 3D printed XBOX One Controller stand for Batman Vs Superman controllers from Gamersoption.com. I detailed the full build on my YouTube Channel for Filament Friday.
The base used PLA and the symbols used ABS. Printed on a MAKERFRONT and Fabrikator Mini 3D printer.
This was fun to make and came out better than I expected. It's shared on Thingiverse.
1 Comment
11/13/2016 10:57:50 pm
Your post is really good. Useful content. Very helpful to me. Leave a Reply. |
Categories
All
Visit previous blog posts in the archives below.
Archives
February 2018
About ChuckChuck has been programming with PIC Microcontrollers since there were only five devices. Now there are over 700 and growing. He also has a lot of fun 3D printing designs using his Davinci 3D printer and TinkerCad software. In this series of blog posts and occasional videos on his YouTube Channel he tries to help you get started with electronics and 3D printing. Disclaimer |
RSS Feed
