Makercase (makercase.com) has released an updated version that allows you to adjust the tab size for Finger and T-Slot joints. It's limited to 1/2 the smallest side of your box but this is a great addition to this handy application. The adjustment shows up as a slide under the box picture when you select Finger or T-Slot. Below are two examples of a box adjusted for different tab sizes. Even more noticeable is the T-Slot. You can reduce it down to essentially just T-Slot connections and no tabs in between. I like this new feature a lot. Check it out and let makercase know we sent you.
0 Comments
Leave a Reply. |
Categories
All
Visit previous blog posts in the archives below.
Archives
February 2018
About ChuckChuck has been programming with PIC Microcontrollers since there were only five devices. Now there are over 700 and growing. He also has a lot of fun 3D printing designs using his Davinci 3D printer and TinkerCad software. In this series of blog posts and occasional videos on his YouTube Channel he tries to help you get started with electronics and 3D printing. Disclaimer |
- Books
- Chuck's Blog
- YouTube Channel
- About Chuck
- 3D Printing
- Getting Started with PICs
- Build Your Own PICKit 2
- CHIPINO
- CHIPAXE Breadboard Modules
- Understanding Hex Files
- chipKIT
- Newsletter Archive
- Contact
- Retired Designs
- Downloads
- Kickstarter Projects
- Great Cow Basic Site
- Buy Hardware
- Links I Recommend