For years I've considered teaching classes based on my books. And now I'm getting closer to making that a reality. What I'm trying to determine is how much interest there is within my list of blog readers. I'm considering 1 or 2 - four hour classes depending on the topic. Weekend or evening. And in Michigan or Florida or both. Cost would be $100-$150 and would include the book. Hardware (programmer, PIC, components) would be supplied for students to use. Student has to supply the Windows laptop (or Mac with Windows installed).
If you could cast your vote below to give me some feedback, I would appreciate it. Also if you have comments or suggestions for the classes, comment below or send me an message through my contact us page (link at the bottom).
|
0 Comments
Leave a Reply. |
Categories
All
Visit previous blog posts in the archives below.
Archives
February 2018
About ChuckChuck has been programming with PIC Microcontrollers since there were only five devices. Now there are over 700 and growing. He also has a lot of fun 3D printing designs using his Davinci 3D printer and TinkerCad software. In this series of blog posts and occasional videos on his YouTube Channel he tries to help you get started with electronics and 3D printing. Disclaimer |
RSS Feed
